WPC Dot Matrix Driver Board-PinLED for Bally/Williams
WPC Dot Matrix Driver Board-PinLED for Bally/Williams
 
Price: £79.00 Exc VAT

Stock Status:(Out of Stock)

Product Code: 10031
Qty:

Description
 
A high quality German made replacement Dot Matrix Driver Board compatible with Williams WPC89 and WPC-S pinball games. The board that this replaces is Bally / Williams part numbers A-14039 (all versions).

See game listing below to see the specific game titles that this board supports.

This board is a direct plug in replacement for the original OEM driver board.

The high voltages produced by this board are nominally set for -120V, -106V and +64V. These voltages can be adjusted but you would need to change resistor values!

Key Benefits

Product Description

A new development of the Dot Matrix Controller Board A-14039 / A-14039-1. This PinLED Dot Matrix Controller Board is a direct replacement for defective original boards. The board has brand new innovations and has this two advantages:

  • New Digital Section
  • New Power Supply Section

A complete circuit board redesign with new parts. The latest modern parts are used on this board and this will help to eliminate all of the bad failures that are found on the old boards.

  • The new development of the digital section:. The board was a “TTL grave”. The Williams designer used over 33 ICs (A-14039) or rather 34 ICs (A-14039-1) plus one CMOS RAM. This was 520 (plus 28 for the CMOS RAM) IC- pins to solder with the board. All these soldering pads are potential sources of errors. Quite apart from the troubleshooting in this section of the original board. Quite often the fault was found after the fifth or sixth change of a IC. What a waste of time and money! With the state of the art technique of today it is possible to use programmable ICs. It is possible to combine all the functions of the original 33 or 34 ICs on one chip. A modern IC called a PLD is used on the board and this PLD has only 100 pins. We have removed all the mistakes of the original design. We have changed the original asynchronous design to a much more better running synchronous design.
  • The new development of the power supply: We have halved the number of parts in the power supply section on this Dot matrix Controller Board. In the original design from Williams they used eight transistors to produce the three supply voltages. On our board only two high- voltage adjustable regulators are in charge for the production of the three voltages. On this board it is possible to adjust the output voltages with four dip switches. With this feature you can adjust each voltage in four steps (e.g. for the -125 Volt you can adjust the voltage between -112 to -125V). With this feature it is possible to drive old displays with a higher voltage and new displays with a lower voltage. There are also six LEDs on our board to display the availability of each voltage level (+3,3V, +5V, +12V, +62V, -113V, – 125V). With them it is easy to locate the voltage section for missing voltages.
  • INSTALLATION INSTRUCTIONS – http://www.pinled.de/pages/support/english/10031.php

Game Listing

Addams Family Addams Family Gold Black Rose Corvette Creature From the Black Lagoon Demolition Man Dirty Harry Dr. Who Dracula Fish Tales Flintstones Funhouse Gilligan's Island Harley Davidson Hurricane Indiana Jones Indianapolis 500 Jackbot (DMD Version Games Only) Johnny Mnemonic Judge Dredd No Fear Party Zone Popeye Road Show Slugfest Star Trek the Next Generation Terminator 2 The Getaway The Machine BOP The Shadow Theater of Magic Twilight Zone White Water Who DunnitWorld Cup Soccer '94



Browse for more products in the same category as this item:

Pinball Display Driver Boards- early and Dot Matrix.